Jump to year -> [1990-01-01] [1994-09-01] [1999-02-23]
[SI]: 03200 Mechanical Engineering Documents

Documents below are listed chronologically. Use the links on the left or below to filter documents by keyword. Use the links above to jump to a specific year on this page.

Number of files: 31

    1990-01-01---------Jump to [Top]
  1. Mechanical Equipment, Course PI 30.1, Nuclear Training Centre, OPG, 1990-01-01. Doc type: Course.
    Summary:
    Keywords: [Concept] - [SI] 03200 Mechanical Engineering [Discipline] Mechanical Engineering [Topic] Fluid Mechanics [Phase] Concept Design Operation [Audience] College Engineer Technician Ugrad
    - Full Course 20043200.pdf (5736 kb)
    - PI 30.10-0 Introduction and Objectives, 20043201.pdf (392 kb)
    - 430.10-0 Identification and Coding of Mechanical Equipment, 20043202.pdf (251 kb)
    - 430.10-1 Centrifugal Pumps, 20043203.pdf (379 kb)
    - 330.10-1 Centrifugal Pumps, 20043204.pdf (795 kb)
    - 430.10-2 Positive Displacement Pumps, 20043205.pdf (168 kb)
    - 430.10-3 Compressonrs - Dynamic and Positive Displacement, 20043206.pdf (270 kb)
    - 430.10-4 Air System, 20043207.pdf (82 kb)
    - 430.10-5 Fans, 20043208.pdf (57 kb)
    - 430.10-6 Vacuum Pumps, 20043209.pdf (185 kb)
    - 230.11-1 Compressors, 20043210.pdf (226 kb)
    - 330.11-1 Heat Exchangers, 20043211.pdf (218 kb)
    - 430.12-1 Piping and Tubes, 20043212.pdf (271 kb)
    - 430.13-1 Valves, 20043213.pdf (513 kb)
    - 430.14-1 Lubrification, 20043214.pdf (143 kb)
    - 430.14-2 Unit 1 Bearings, 20043215.pdf (68 kb)
    - 430.14-2 Unit 2 Lubrification Methods, 20043216.pdf (62 kb)
    - 430.14-2 Unit 3 Bearing Design and Installation, 20043217.pdf (81 kb)
    - 230.12-1 Lubrification, 20043218.pdf (250 kb)
    - 430.15-1 Sealing Devices, 20043219.pdf (181 kb)
    - 330.14-1 Axial Mechanical Seals, 20043220.pdf (190 kb)
    - 230.13-1 Shaft Couplings, 20043221.pdf (204 kb)
    - 230.13-2 Belt Drives, 20043222.pdf (247 kb)
    - 230.13-3 Chain Drives, 20043223.pdf (115 kb)
    - 230.13-4 Gears and Gearing, 20043224.pdf (250 kb)
    - 230.16-1 Gas Turbines, 20043225.pdf (289 kb)
    2. 1994-09-01---------Jump to [Top]
  2. Mechanical Equipment, Course 23001, OPG, 1994-09-01. Doc type: Course.
    Summary:
    Keywords: [Concept] - [SI] 03200 Mechanical Engineering [Discipline] Mechanical Engineering [Topic] Fluid Mechanics [Phase] Concept Design Operation [Audience] College Engineer Technician Ugrad
    - Full Course 20042800.pdf (1261 kb)
    - Intro and Table of Contents, 20042801.pdf (44 kb)
    - Module 1 Centrifugal Pumps and Systems, 20042802.pdf (1034 kb)
    - Module 2 Positive Displacement Compressor Operation, 20042803.pdf (194 kb)
    3. 1999-02-23---------Jump to [Top]
  3. Single Phase Friction Factors for MNR Thermalhydraulic Modelling, by Wm.J. Garland, McMaster University, 1999-02-23. Doc type: Other.
    Summary: This report documents a review of selected literature to determine the appropriate correlations to use for McMaster Nuclear Reactor safety analysis.  It was found that the standard Moody diagram (which is based on the transcendental Colebrook equation) is sufficiently accurate for pipe flow but problematic to program, whereas simple approximations do not account for pipe wall roughness.  Herein, a very simple function is offered that returns an accurate estimate of f as a function of Reynolds Number, Re, and relative roughness e/D in a non-iterative fashion.  In addition, a simple correction factor for channel flow is offered.
    Keywords: [Concept] - [SI] 03200 Mechanical Engineering; #33000 Primary Heat Transport System [Discipline] Mechanical Engineering [Topic] Fluid Mechanics Modelling [Phase] Concept; #Design [Audience] College; #Engineer; #Grad; #Technician; #Ugrad
    - 1phase1.xls (552 kb)
---end of page---